Enable Sensor Re-lock


Tap on the lock and enter *22#<Master PIN>#

This will enable your mortise to lock automatically when it senses that the door is closed.


Enable Timer Re-lock


Tap on the lock and enter *20#<Master PIN>#<5-120 seconds>#

This will enable your mortise to lock automatically after the set time. If you have both Sensor and Timer Re-lock enabled, Sensor Re-lock will take priority i.e. the Mortise will not lock after the Timer is up when the door is open.


Disable Sensor Re-lock


Tap on the keypad and enter *23#<Master PIN>#

If you disable Sensor Re-lock, and Timer Re-lock is enabled, the Mortise will lock regardless of whether the door is open or closed.


Disable Timer Re-lock


Tap on the keypad and enter *21#<Master PIN>#

If you disable Timer Re-lock, and Sensor Re-lock is enabled, the Mortise will lock when the door is closed.


See below for Mortise lock behaviour under different combinations of re-lock status:


 Sensor Re-lock EnabledSensor Re-lock Disabled

Timer Re-lock Enabled


Mortise will lock upon door closure.

Should the door be kept open after Timer is up, door will not lock until door is closed.

Should door be kept closed after unlocking, door will auto-lock after Timer is up.


Mortise will lock when Timer is up, regardless of whether door is open or closed.

Timer Re-lock Disabled


Mortise will lock upon door closure.

Should door be kept closed after unlocking, door will not auto-lock.


Manual lock mode:

Door will not re-lock automatically.


Note: By default, Sensor and Timer (60 seconds) Re-lock are enabled. If you wish to lock the door manually, you will have to disable both Re-lock Modes.